Hey Wayne!
It was a combination of videos, reading, etc...
Super easy.
Prep:
With damp cloth wipe down all the emblems, use a damp qtip to get in the little nooks.
Paint tape around the emblems leaving about 1-2” between the tape and emblem.
All I had was a bunch of printer paper, but it worked. Masked the whole area as photographed.
Depending on where you live, it’s suggested the Plasti Dip can is a bit warmer. I just set mine on the asphalt by my garage.
Paint:
Before each coat - Shake the can for about a minute and spray some test shots.
#1) Spray the emblem for about 50% coverage.
Wait 30 minutes.
#2) Spray more coverage
Wait 30 minutes
#3 - #5) Sprays even more coverage, get at the angles to get on the sides of the emblems.
Wait 30 minutes.
At the 30 minute mark, start removing all the tape and paper. Then peel the plasti dip off really slowly, especially close to the emblems.
I had to get into the nooks with toothpicks to get the paint out.
And then I read wait 24 hours for it to cure from water, car wash, etc...it’s definitely tacky feeling still. Will check it tomorrow and see.
The awesome part about this is if you F-it up, it just peels off. I tested the inside of my door to double check before starting!?
And another member here, (Mezzfin), had a modern steel he did and that’s what sold me. I had to see my color. ?
