Honda Passport Forum banner
1 - 3 of 24 Posts
View attachment 1113

RIMS:
Brand: Black Rhino
Model: York
Part #: 1880YRK355120M76
Color: Matte Black
Diameter: 18"
Width: 8"
Offset: 35

TIRES:
Brand: Nitto
Model: Ridge Grappler
Color: Agressive Orientation
Size: 265/60 R18

Price:
$2500 total, installed with calibration

Not sure if hub centric or lug centric, I'm planning to take it to a tire shop to see if the dealer in fact put centering rings in.

View attachment 1105

FIT:
There is the slightest bit of rub on the outside rear corner of the wheel in the wheel well when turned as far as possible on flat ground. It is barely making contact with the plastic fender liner at a place where the liner is flexible and has about half an inch of flex before contacting the underlying metal. The rub is so slight that I couldn't hear it inside the vehicle and only found it on visual inspection. I think it's safe to say that this is the outer limit of size.

WHEEL IS TURNED HARD RIGHT

REAR OF FRONT RIGHT WHEEL WELL:

View attachment 1097
View attachment 1103



FRONT OF FRONT LEFT WHEEL WELL:

View attachment 1099
View attachment 1101
Those look really nice. Is the calibration you mention for correcting the minor speedometer change with taller tires or are you refering to the TPMS?
 
Thanks for the reply, I guess I will check the speedo with the stock tires and again with the bigger tires before I worry about it. Likely just going to 265/50R20. Almost an inch in height is not insignificant but if it is reading fast stock maybe it will be acceptable close with the bigger tires. Just signed on the Passport last Friday but it is still in route to the dealer.

Do you mind sharing what dealer did yours? I'm not near you but I could call them and get the scoop.
 
1 - 3 of 24 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.