Honda Passport Forum banner
1 - 5 of 5 Posts
Discussion starter · #1 ·
OK, got my set of crossbars from the dealer and am stymied at the "remove plastic trim" in step 1! Took out the Torx screw, but I don't see any obvious place to pry up and release a tab or two. I know the rear section slides back and then up, but anyone have any specific input to help me get started? As you can imagine, I'm not eager to break/gouge/mar anything on my new PP Elite!
 
I was able to pop the cover off with a thin flat head screwdriver. Takes a bit of force. There are 2 posts. One comes out with wedging the screwdriver in at the end and lifting up. Then sliding the cover toward the back to the vehicle. No damage thankfully.
 
  • Like
Reactions: Mezzfin
1 - 5 of 5 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.